 |
1. From the patient list screen, select the patient you would like to test and select “New Test”. Following the onscreen prompts select “Knee”. |
 |
2. Push the button on the side of the ViMove2 sensors to turn them on. From the sensor selection screen, tap on the sensors with the corresponding serial numbers. |
 |
3. Peel the Sensor Adhesives off the adhesive roll and apply to the back of the ViMove2 sensors. |
 |
4. Using the ViMove2 Tibia template place the zero line of the ruler on the inferior border of the medial malleolus and mark the shin bone at the appropriate height demarcation. |
 |
5. Place the ViMove2 sensor on the tibia in portrait orientation so it sits in the middle of the line drawn in step 4 with the sensor light located in the top corner. |
 |
6. Repeat steps 4 and 5 for the opposite leg. Ensure that both sensors are placed at equal heights on the shin. |
 |
7. Following the on-screen prompts, ensure the sensors have been placed correctly. If the sensor placement is correct select “Yes” in the ViMove2 app. If the sensor placement is incorrect select “No, swap colors”. |
 |
8. Select the knee tests you would like your patient to perform. After the tests have been selected press “Begin” to start the assessment. |